Jūsų krepšelis tuščias.
Produkto aprašymas
MATCH M 5DSP itin mažas automobilinis stiprintuvas 5-kanalų su integruotu 7-kanalų DSP 320W
Geriausias metų garso stiprintuvas automobiliui EISA 2016-2017 apdovanojimas.
Mažas kaip kortų kaladė, bet galingas savo muzika ir skaidrumu. Naujasis M 5DSP stiprintuvas duoda didelią galią ir naujausias technologijas neįtikėtinai mažoje pakuotėje
| Galia RMS / max. | |
| Priekiniai/galiniai kanalai@ 4 Ohms “HighPower” režime |
4 x 60 Watts / 120 Watts |
| Priekiniai/galiniai kanalai@ 4 Ohms “MidPower” režime |
4 x 35 Watts / 70 Watts |
| Žemų dažnių garsiakalbis @ 4 Ohms | 1 x 90 Watts / 180 Watts |
| Žemų dažnių garsiakalbis@ 2 Ohms | 1 x 160 / 320 Watts |
| Dažnių diapozonas | 20 Hz - 20,000 Hz |
| Išmatavimai | 35 x 85 x 110 mm |
Savybės:
Protinga Highlevel jungtis
The latest generation of OE car radios incorporates sophisticated possibilities of diagnosing the connected speakers. If an usual amplifier will be hooked up failure messages and loss of specific features (e.g. fader function) are often the result - but not with the M 5DSP. The new ADEP circuit (Advanced Diagnostics Error Protection) avoids all these problems without loading the speaker outputs of the OE radio during high volumes unnecessarily.
Du galios rėžimai
The M 5DSP has two power modes - the “HighPower” mode for maximum performance and “MidPower” mode with reduced output power and lower power consumption for Plug & Play applications.
Automatinis skaitmeninio signalo aptikimas
Switching from analog input to the digital input is done automatically as soon as a signal is detected on the Optical Input. This feature can be deactivated in the DSP PC-Tool software. Alternatively you can use an optional remote control for manual switching between analog and digital inputs.
Energijos taupymo rėžimas
The “Power Save Mode” is incorporated in the basic setup of the DSP PC-Tool software. It allows to significantly reduce the power consumption of the M 5DSP (or any additional connected amplifier) once there’s no input signal for more than 60 seconds. Please note that in many up-to-date cars with “CAN” or any other internal bus structures it may happen that the car radio (and therefore the M 5DSP as well) remains “invisibly” turned on for up to 45 min. after leaving the car! Once the “Power Save Mode” is active the output stages of the M 5DSP and its remote output will be turned off, thus reducing current
draw to less than 250 mA. The amp will turn again to full operation within 2 sec. if a music signal is applied. It is possible to either modify the turn-off time of 60 sec. or completely deactivate the “Power Save Mode” via the DSP PC-Tool.
